PROGRAMMING
CODE LEARNING PROGRAMMING:
The RS900ER will learn up to 4 different transmitter security codes. This procedure does not apply to the RS901
add-on Remote Start module.
Transmitter Programming:
1) Open Hood(Gray wire grounded).
2) Depress and Hold BRAKE PEDAL, and then Press Program Button until parking lights turn ON solid.
3) Release program button.
4) With BRAKE Depressed, Press and Hold program button again.
5) Within 4 seconds press any button on transmitter.
6) Parking lights will flash once to confirm programming. Release Remote and Program button after confirmation.
7) CLOSE HOOD FIRST, Then press and release BRAKE PEDAL to clear parking lights.
Tach Reference Programming:
1) Open Hood(Gray wire grounded), Start Engine.
2) Depress and Hold BRAKE PEDAL, and then Press Program Button until parking lights turn ON flashing.
(Tach-Finder mode is now engaged).
3) Release program button.
4) With BRAKE Depressed, Press and Hold program button again, Parking lights will be on solid (not flashing).
Tach reference is now learned.
5) Release Program Button, Parking Lights will begin flashing again.
6) CLOSE HOOD FIRST, Then press and release BRAKE PEDAL to clear parking lights.
Programmable Options:
This system has several installer programmable features. Below is a brief description of these features.
Option #1 - Crank Time:
This programs the amount of time the starter cranks. This programming works ONLY when Option #2 (Engine
Sense) is programmed to Value 2 (Timed Crank).
Option #2 - Engine Sense:
This programs the TYPE of Engine monitoring the system uses. Value 1 (Tach sensing) is the most reliable and
accurate. Value 2 (Timed Crank) is for "Semi-Tachless Mode” when there is only poor or dirty tach signals that
cannot be cleaned up. Value 3 (Vacuum) This requires installing an additional Vacuum Switch.
Option #3 – Remote Auxiliary Output:
This programs the remote output of the system for activating a trunk release. Value 1 is No Output. Value 2
enables the output to operate on Multi-Function Output Wire #2 (Orange wire). Value 3 enables the output to
operate on Multi-Function Output Wire #1 (Tan wire).
Option #4 - Double Unlock Pulse:
Programs UNLOCK Pulse to be either a single or double pulse. Makes the installation into vehicles such as
Nissan's and Volkswagens that require an additional pulse for Factory DISARM very easy.
Option #5 - Lock after Remote Start TIME-OUT or ABORT:
Programs system to re-lock power door locks after remote engine start turns off. This is to ensure that vehicles
which come equipped with factory ignition controlled door locks will not leave the vehicle unlocked. (Many GM’s
such as Buick)
Option #6 – Run Time:
Program the desired run time for remote start. The programmed run time also applies to the Idle-Down feature.
Value 1 is 10 min., Value 2 is 20 min., and Value 3 is 40 min.
SEE PROCEDURE and CHART on NEXT PAGE for EASY OPTIONS PROGRAMMING.
Summary of Contents for COOL START RS-901
Page 14: ......
