Crighton Engineering Magnum p100, Maintenance Manual, Page: 3 / 7

To replace the glass seal tape:
ove and carefully peel off the old ladder tape around the edge.
ge of the glass so
the firebox and will cause st
it the glass back into the retainer frame, ensuring that the original outer surface of the glass is
again going to be on the outside of the door.
frame.
e behind the hinge and rotate the left side
back into the door frame to align it with the screw holes. Refit the screws.
Remove the glass as detailed ab
Clean the glass to remove any soot or creosote. Do not use abrasive cleaners.
Fit new ladder tape to the edge of the glass ensuring it is centered on the ed
that an equal amount of tape will extend down both faces of the glass when it is folded down.
Make sure that the ends of the tape meet tightly at the join. A gap here will allow air leaks into
reaking of the glass with soot.
F
Refit the glass and retainer back into the door
Place the two lugs on the right side of the retainer fram
Refit the door rope.