![background image](http://html1.mh-extra.com/html/cricket/esv/esv_installation-instructions-and-wiring-diagram_2685496006.webp)
Cricket Remote Control Installation
1. Remove the Controller Tray Cover.
2. Using wire cutters carefully cut the lug off the Red cable on
WH1. Make sure your cut is as close to the lug as possible.
3. Strip the wire insulation off the end of the wire you cut to lug
off to reveal at least ¼ of exposed wire.
4. Inside the Controller Tray Remove the U-Shaped brackets
holding the wire harnesses in place. Then remove the four
Motor Power Supply cables directly above the 16 pin White
connector on the Controller.
5. At the Controller locate the Red and Black cables shown in the
diagram and disconnect them from the Controller.
6. Connect the Blue cable from WH1 to the Freewheel Electronic
Switch as shown in the diagram. Cricket Carts that do not have
this switch see
Appendix A
7. Route the Black cable with a lug from the WH1 and connect it
to the Negative Battery Terminal on the driver’s side battery.
CAUTION
:
Be carful using a wrench on the battery terminal not
to touch the other exposed terminals. Serious damage to the
golf cart or personal injury could result in shorting the battery
terminals.
6
Rev 01222019 © 2020 Melbourne Cricket