Placing onto a Flat Surface
When placing the device onto a flat surface or stacking it with other
equipment, attach the included feet near the corners on the underside of
the device.
Make Connections
Hardware Hookup
Make the necessary connections as called out in
When making connections to the ZUM-FLOOR-HUB, note the following:
l
Use Crestron power supplies for Crestron equipment.
l
The included cable(s) cannot be extended.
NOTES:
l
Ensure the unit is properly grounded by connecting the chassis
ground lug to an earth ground (building steel).
l
The ZUM-FLOOR-HUB can be powered by the 4-position terminal
block connector labeled NET or with the (included) 24 VDC power
pack.
Connect the Control Subnet
The ZUM-FLOOR-HUB has a dedicated Control Subnet that is used for
communication between the control system and Crestron Ethernet
devices. This subnet allows for dedicated communication between the
control system and Crestron Ethernet devices without interferences
from other network traffic on the LAN.
NOTE:
Do not connect the CONTROL SUBNET port to the LAN. The
CONTROL SUBNET port must be connected only to Crestron Ethernet
devices.
For details on using the Control Subnet, refer to the
(Doc. 7150).
2
ZUM-FLOOR-HUB
Zūm® Floor Hub