Install the Speaker Cable
Run the speaker cable (not included) from the audio source to the
speaker location, observing all appropriate local codes. Strip the ends of
the speaker cable approximately 0.25 in. to 0.50 in. (~6 mm to ~12 mm)
and twist the strands.
Connect the Speaker Cable
Connect the speaker cable (not included) to the spring terminals by
pressing the top of the terminals down and inserting the exposed
strands into the hole. Make sure that the positive wire is attached to the
red connection, and the negative wire is attached to the black
connection.
Mount/Remove the Speaker
1. Fit the speaker into the bayonet ring. Then twist the speaker about 15
degrees clockwise into place. When the speaker is properly seated,
the indicators on the ring and the speaker line up.
NOTE:
The indicators must line up to ensure the speaker is properly
seated. The speaker must be properly seated, or the metal lock tab
will not lock.
3
ULTIMATE IC6-AW-W-T-EACH
Quick Start
Ultimate 6.5 in. 2-Way All Weather In-Ceiling Speaker, White Textured, Single
