Software
Crestron
Touch The PC Driver
Driver Requirements
REQUIREMENT SPECIFICATION
Touch the PC V2 (UPDD*)
Version 3.08.34 or later
1
VisionTools Pro-e
Version 3.2.06 or later
1
Crestron Isys
®
Touchpanel firmware
Version 2.006 or later
2, 3
Crestron Database
Version 16.2 or later
PC Requirements:
Available Hard Disc space
Operating System
5 MB
4
Microsoft Windows
®
98/XP/2000/NT
* Universal Pointer Device Driver
1
The latest versions can be obtained from the Downloads | Software Updates section of the Crestron
website (
. Refer to NOTE below.
2
The TPS-RFGWX and touchpanels with later versions of firmware may include features not
mentioned in this guide. Newer versions of this guide can be obtained from the Downloads | Product
Manuals section of the Crestron website (
3
The firmware upgrade files can be obtained from the Downloads | Software Updates section of
Crestron’s website. Crestron recommends that the latest firmware be loaded into the touchpanel.
4
The PC requirements pertain only to the Touch the PC V2. Additional requirements for SIMPL
Windows and/or VT Pro-e are not included. Refer to the documentation supplied with the software
for further information.
NOTE
: Crestron software and any files on the website are for Authorized Crestron
dealers and Crestron Authorized Independent Programmers (CAIP) only. New users
may be required to register to obtain access to certain areas of the site (including the
FTP site).
Quickstart Procedure
This section contains brief descriptions of the steps required for utilizing the Touch
the PC V2 program via serial, Cresnet, or Ethernet communication.
NOTE:
In the following procedures, if the
Touch The PC V2
selection does not
appear, update the Crestron Database to version 16.2 or later.
Touch the PC V2 Operation via Serial Communications
•
Install Touch the PC V2 software (page 3)
•
Change the touchpanel RS-232 settings to RS-232 port for Touch Output
(page 5)
•
Connect the PC COM port to the RS-232 port of the touchpanel using RJ-
11 modular cable and adapter, Crestron part number 15556 (page 5)
•
Install touchpanel firmware, version 2.006 or higher
•
In VT Pro-e (page 14):
- Set the RGB object to PAD 1 or PAD 2
- Set the project properties according to the RGB selected PAD area
Select:
Touch the PC, V2
Communication via:
Serial
- Save, compile, and load the project to the touchpanel
2
•
Touch the PC Driver
Programmer’s Guide – DOC. 5916B
Summary of Contents for Touch The PC Driver
Page 4: ......
