Swivel Mount Kit
Crestron
SMK-12/15/17
SMK-12/15/17 Swivel Mount Kit Assembly Diagram
FRONT
From
Interface
Box
To Touchpanel
Ports
MOUNTING SURFACE
SECURITY PLATE (2004824) QTY 1
Route Cables
Through This
Opening
SWIVEL MOUNT ASSEMBLY
SWIVEL MOUNT PLATE
#8-32 X ¼ PAN HEAD SCREW
(2014325) QTY 4 TOTAL
#8-32 X ¼ PAN HEAD SCREW
(2007263) QTY 4 TOTAL TO MOUNT
THE SWIVEL MOUNT PLATE TO
THE BASE OF THE TOUCHPANEL
#8-32 X 1" PAN HEAD SCREW
(2007276) OR #8-32 x 5/8"
(2007274) QTY 4 TOTAL
BENT TAB
FLAT TAB
SPRING-LOADED
SCREWS
8. Route the cables from the interface box up through the Security Plate,
through the mounting surface, through the Swivel Mount Assembly, and
then through the opening in the base of the touchpanel. Connect the cables
to the appropriate touchpanel ports. Route the cables carefully to avoid
chafing.
9. Being careful to avoid damage to the cables, attach the Swivel Mount
Assembly to the Swivel Mount Plate, using the supplied four #8-32 X ¼”
screws through the holes in the Swivel Mount Assembly into the standoff
posts on the Swivel Mount Plate. Make certain the cables are not twisted or
crimped and have sufficient slack at the port connections before fully
tightening the screws.
10. Making certain that the tabs (one bent and one flat) are positioned to the
front and rear of the Swivel Mount Assembly, place the touchpanel and
Swivel Mount Assembly down on the mounting surface. Guide the standoff
posts on the Swivel Mount Assembly through the holes you drilled in the
mounting surface.
4
•
Swivel Mount Kit: SMK-12/15/17 Installation
Guide – DOC. 6467
