Prodigy™ Media System
Crestron
PMC2
XPanel (if equipped)
To set the temperature:
•
Single Setpoint:
Click
k
or
j
to raise or lower the temperature setting.
NOTE:
When using a single setpoint, there is a 20-minute change
limiter to prevent system toggling.
•
Dual Setpoints:
1. Verify that the controlled zone is set to the
Auto
mode.
2. To lower the heating or cooling setpoint, click the
j
button
under the setting to be changed. To raise the heating or
cooling setpoint, click the
k
button under the setting to be
changed.
Set the System Mode
A Prodigy-controlled HVAC zone has up to five operating modes:
NOTE:
Not all modes are available for all HVAC zones.
•
•
•
•
•
OFF
: In
Off
mode, all HVAC systems are disabled.
HEAT
: In
Heat
mode, the thermostat uses the heating system to
maintain the setpoint temperature. On the P-TSTATRF, a “flame”
icon will be displayed.
AUXILIARY (AUX) HEAT MODE
: In
Auxiliary Heat
mode, the
thermostat uses only the auxiliary heat output on heat pump or dual-
fuel systems (if equipped) to maintain the setpoint temperature. This
setting can be useful when the heat pump is being serviced or when
there is an unexpected problem with it. On the P-TSTATRF, the
display will flash the flame icon when the system is in
Auxiliary Heat
mode.
COOL
: In
Cool
mode, the thermostat uses the cooling system to
maintain the setpoint temperature. On the P-TSTATRF, the
“snowflake” icon will be displayed.
AUTO
: In
Auto
mode, the thermostat allows the system to switch
between
Heat
and
Cool
automatically as needed to maintain the
setpoint temperature. On the P-TSTATRF, the display will show the
flame and snowflake icons.
P-TSTATRF
The system mode of the P-TSTATRF is set by the
MODE
button.
To set the system mode, press and release the
MODE
button until the
desired mode is displayed. The unit will cycle through all available system
modes in the following order:
Off
,
Heat
,
Auxiliary Heat
(for heat pump and
dual-fuel systems),
Cool
and
Auto
(if enabled).
NOTE:
Not all modes are available for all HVAC zones.
PLX2
To set a controlled zone’s system mode with the PLX2:
1. Select the zone to be controlled as described on page 46.
52
•
Prodigy Media System: PMC2
System User Guide – DOC. 6840A
Summary of Contents for Prodigy PMC2
Page 1: ...Prodigy System User Guide Prodigy System User Guide ...
Page 4: ......
