Isys™ 2.8” Handheld Wireless Touchpanel
Crestron
MTX-3
NOTE:
The MTX-3 can become unresponsive when battery strength is low.
Battery Calibration
For optimum performance after shipping or any time the unit’s power has been off
for an extended period of time, Crestron recommends the following procedure be
performed:
1. Place the unit on its docking station/charger and connect AC power.
2. Allow the unit to charge completely. (The green LED should be steady on
for 15 minutes.)
3. Remove panel from the docking station/charger.
4. From the main setup screen, touch
Diagnostics
, then touch
Battery Diags
to go to the
Battery Diagnostics
screen. Touch
Recondition Battery
, then
touch
YES, Recondition Battery
to confirm. (Refer to “Configuring the
Touchpanel” which starts on page 13.)
5. Wait for the unit to shut off. This takes approximately five hours. Leave the
unit off the dock the entire time. During this operation, the
Battery
Reconditioning
screen shown on page 25 will be displayed until the unit
shuts off.
6. Place the unit back on the docking station and allow it to charge completely.
7. Unit is now ready for normal operation.
Optimizing Battery Life
In order to maximize battery life, use the following settings:
1. From the main setup screen, touch
Standby Setup
to enter the
Standby
Timeouts
screen (refer to “Standby Setup” on page 18). Use an
Undocked
Standby
setting of 30 and an
Undocked Power Off
setting of 45.
2. From the main setup screen, touch
LCD Settings
to enter the
Display
Settings
screen (refer to “LCD Settings” on page 22). Use an
Undocked
Brightness
setting of 50.
12
•
Isys™ 2.8” Handheld Wireless Touchpanel: MTX-3
Operations Guide – DOC. 7066B
Summary of Contents for MTX-3
Page 4: ......
