Mud Mount Kits
Crestron
MMK-4000L & WMKM-4000L
2. Slide a push-on fastener over each pin of the PMK-4000L (or
BB-4000L) to loosely secure the fastener plate and the mounting plate.
Do not push the push-on fasteners all the way down onto the pins. Slide
them on enough to keep the fastener plate and mounting plate as one
fastener/mounting plate assembly.
3. Use the second fastener plate and repeat steps 1 and 2 using the lower
two PMK-4000L (or BB-4000L) pins.
NOTE:
When installing into the PMK-4000L, verify that the 18 AWG bus wire
securing the cables for the touchpanel remain attached.
4. Verify that the drywall cutout meets the measurements specified on
page 2.
5. Insert the symmetrical mud ring plate into the opening, as shown in the
illustration after this step.
Insert and Secure Mud Ring Plate into PMK-4000L (or BB-4000L)
(2011517)
HOLES FOR DRYWALL SCREWS (PROVIDED BY
OTHER), SCREW LENGTH SHOULD NOT EXCEED
DRYWALL THICKNESS BY MORE THAN 1/2".
MUD RING PLATE
PMK-4000L
DRYWALL
FLANGE
6. When the mud ring plate is in position, bend the top two flanges of the
plate upward and the bottom two flanges downward.
•
If mounting into the PMK-4000L, bend the flanges
approximately 90 degrees.
•
If mounting into the BB-4000L, bend the flanges back as far
as they can go.
4
•
Mud Mount Kits: MMK-4000L & WMKM-4000L
Installation Guide – DOC. 6303
