4. Ensure that all four swiveling dogs are tucked inside of the FT2
assembly, and then insert the FT2 assembly into the mounting hole
until the top lip is flush with the table surface.
5. Carefully tighten the four swiveling dogs in each corner of the FlipTop
assembly clockwise until the FT2 assembly is secured in place against
the table. Do not overtighten the swiveling dogs.
CAUTION:
A screwdriver or manual torque screwdriver at its lowest
setting may be used to tighten the swiveling dogs. Avoid stripping
the swiveling dogs and damaging the table.
If removing the FT2-1200-ELEC-PTL from the table, ensure that
the screwdriver rotation is set correctly before loosening the
swiveling dogs.
Connect the FlipTop Assembly
Access the two network connectors and two power bus barrel jacks on
the underside of the FT2 assembly.
Connect the Network
Automate the one-touch retractors by connecting all retractors in an
FT2 assembly to a control system and a switch, or to a DMPS via a single
Cresnet® cable. Custom programming can trigger the retractors after
five minutes of no video detected.
Connect the FT2 assembly to a Crestron control system or DMPS3 via
the 3-pin connector using standard Cresnet cable. The red power lead is
not connected and should be terminated.
3
FT2-1200-ELEC-PTL
Quick Start
FlipTop™ FT2 Series Cable Management System, 1200 Size, Electrical, Pass-Through Lid
