Install the Modules
Installation procedures for most modules are available in separate
product documentation. For more information, refer to the specific
product manual located at
. The following
sections provide best practices and installation procedures for pass-
through cable modules and blank plate modules.
Position the Modules
The FT2-700-MECH, FT2-700-MECH-PTL, FT2-700-MECH-AC, and the
FT2-700-MECH-ACUSB all include FT2A-PLT-PT pass-through cable
modules and FT2A-PLT-BLANK blank plate modules.
In addition, the FT2-700-MECH-AC includes an FT2A-PWR-US-1-BASIC
AC power outlet module. The FT2-700-MECH-ACUSB includes an
FT2A-PWR-US-1-BASIC and an FT2A-CHGR-USBA-BASIC USB rapid
charging module.
Follow the best practices below when performing module installation.
l
Perform module installation in the following order:
1. AC Power Outlet Modules (
series)
2. Retractor modules (
series)
3. All other modules (
series,
series,
, and
l
Place the FT2A-CBLR-GR modules only at the ends of a module row.
l
Dress all cables after installing each module.
Install the Pass-Through Cable Module
The FT2A-PLT-PT pass-through modules enable FT2-CBL-PT pass-
through cables and other types of interface cables to be installed within
the FT2-700 assembly. Each FT2A-PLT-PT cable module is packaged with
one nylon grommet and one cable plate. One empty module slot in the
FT2-700 assembly and one FT2-CBL-PT series or other interface cable
are required for installation.
Installing the Pass-Through Cable Module with 4K Cables
1. Push the connector end of the cable through the hole in the cable plate.
2. Insert the cable plate into one of the three slots in the pass-through
module. Choose the appropriate slot based on the length of the cable
connector. The top of the connector should sit flush with the top of the
module.
NOTES:
l
If the connector extends past the top of the pass-through
module, the FT2-700 assembly lid cannot close.
l
Ensure that the cable moves freely in the module prior to
attaching the side plate. The plate is difficult to remove once it is
attached.
l
The grommet is not needed when installing most 4K cables. If
the cable is 10 mm or thinner, the grommet may be used.
4
FT2-700-MECH Series
Quick Start
FlipTop™ FT2 Series, 700 Size, Mechanical