Power Supply for Crestron Shade Motors
Crestron
CSA-PWS10S-HUB
Installation Guide – DOC. 7438A
Power Supply for Crestron Shade Motors: CSA-PWS10S-HUB
•
9
CSA-PWS10S-HUB Overall Dimensions (Side View)
Installation
The enclosure must be installed by a licensed electrician in accordance with all national and local codes.
CAUTION
: Double pole/neutral fusing implemented.
CAUTION
: The CSA-PWS10S-HUB-CAEN-1X1 houses equipment that needs to be air-cooled. Therefore, mount
in a well-ventilated area. The ambient temperature range should be 32
°
F to 104
°
F (0
°
C to 40
°
C). The relative
humidity should range from 10% to 90% (non-condensing). Allow adequate clearance in front of the vented cover
for servicing and ventilation.
NOTE
: The CSA-PWS10S-HUB-CAEN-1X1 is designed for surface mounting or flush mounting on a wall.
NOTE
: The CSA-PWS10S-HUB is intended for surface mounting on a wall.
NOTE
: Enclosure and power supply are intended for indoor use only.
NOTE
: When flush mounting, 5/8” drywall is preferred.
NOTE
: Four keyholes are located within the enclosure and should be used if surface mounting.
Mounting the CSA-PWS10S-HUB-CAEN-1X1
For surface mounting, the enclosure must be mounted securely to building wall studs or at least 1/4 in (7 mm)
plywood using four #8 screws with four #8 large flat washers (not included) before operation. The enclosure cover
must be installed for normal use.
For flush mounting, the enclosure must be mounted securely to building wall studs using eight #8 screws (not
included) before operation. The enclosure cover must be installed for normal use.
Mounting the CSA-PWS10S-HUB
To surface mount the CSA-PWS10S-HUB, the power supply must be mounted securely to building wall studs or at
least 1/4 in (7 mm) plywood using four #8 pan head wood screws. Use the screw holes indicated in
“CSA-PWS10S-HUB Overall Dimensions” on page 8 to secure the power supply to the mounting surface.
7 7/16 in
(189 mm)
13/16 in
(21 mm)
5/8 in
(16 mm)
7 9/16 in
(194 mm)
