Crestron
CNRFGWA
Wireless
RF
Receiver
Operations Guide - DOC. 8086A
Wireless RF Receiver: CNRFGWA
•
9
2. Refer to the figure after this step. From the Viewport menu, select
Setup | Communications
settings
(alternatively, press
Alt+D
) to open
the “Port Settings” window.
Setup | Communications Settings Command
3. Select
RS-232
as the connection type. Verify that an available COM
port (COM 1 is shown below) is selected, Verify that the baud rate is
set to
38400
(PRO 2 default), the parity is
None
, the data bits is
Eight
,
the stop bits is
One,
XON/XOFF is not selected, and RTS/CTS
is
selected. Click the
OK
button to save the settings and close the
window.
“Port Settings” Window
NOTE:
The parameters shown in the illustration above are the port settings for a 2-
Series control system. Consult the Operations Guide for the control system being
used for exact parameter selection.
4. To verify communication, select
Diagnostics | Establish
Communications (Find Rack)
. This should display a window that
gives the COM port and baud rate. If communication cannot be
established, refer to the “Troubleshooting Communications” section in
the respective Operations Guide for the control system.
Summary of Contents for CNRFGWA
Page 1: ...Crestron CNRFGWA Wireless RF Receiver Operations Guide ...
Page 4: ......
