Crestron CAEN-MK
CAEN Mounting Kit
Mounting
NOTE:
This assembly must be installed in accordance with local building codes.
Tools/hardware required
#2 Phillips tip screwdriver
8B x ¼”L Self-tapping screws (quantity four, supplied)
Flat tip screwdriver (optional)
Complete the following procedure (refer to illustration below) to mount the
assembly.
1. Position the assembly to be mounted in front of an available space in a
Crestron CAEN enclosure (at the bottom of a single-width enclosure or
across two side-by-side spaces in a double-width cabinet) to determine
the location of the mounting holes. After determining the position,
remove the assembly and continue to step 2.
2. Remove any required knockouts to route any required wiring outside of
the enclosure.
3. Using a #2 Phillips tip screwdriver, install four screws (supplied) half
way into the CAEN enclosure.
4. With the assembly in hand, position the large portion of the left
bracket’s keyholes over the screws on the left side of the installation
location. Hold the unit flat against the back plane of the CAEN
enclosure, and slide the slotted portion and right-hand brackets under
the screw heads.
5. Tighten the four screws to secure the assembly to the enclosure.
Install Assembly into CAEN
SCREWS, SELF-TAPPING
8B x
1
4
"L
6. If required, make any AC electrical connections using the supplied DIN
rail terminal blocks and a flat tip screwdriver.
Installation Guide - DOC. 6130
CAEN Mounting Kit: CAEN-MK
•
3
