Decorator Keypads
Crestron
C2N-DBF12 & C2N-DBN12
Hardware Connections for the C2N-DBF12 & C2N-DBN12
(Back view)
CRESNET:
CONNECT
TO THE
CRESNET
CONTROL
NETWORK
Button Replacement
Replacing/changing the removable buttons in a keypad is a simple
process. Refer to the illustration on previous page and the following
procedures.
1. If the keypad is installed in an electrical box, remove the two
1-inch securing screws, carefully pull the keypad from the
electrical box, and disconnect the Cresnet cable.
2. Remove the four screws that attach the divider, and remove the
divider.
CAUTION:
The removable buttons fit snugly on the rubber
membrane and must be removed carefully to avoid pulling the
membrane from the unit. Once the membrane is detached, you may be
unable to reattach it.
10
•
Decorator Keypads: C2N-DBF/N12
Operations & Installation Guide – DOC. 6200A
