Crestron
C2N-DAP8
Digital Audio Processor
Operations Guide – DOC. 8186
Digital Audio Processor: C2N-DAP8
•
25
Set up for communications as follows:
1. Initially,
the
Pass To
check box is not selected indicating a direct
connection from your PC to the C2N-DAP8. Select
Pass To
if your PC and
the C2N-DAP8 are connected through the control system via Cresnet. Make
certain the
Cresnet ID
setting is correct (
is the default for the C2N-
DAP8). Refer to “Identity Code” on page 10 for more information on
setting the Cresnet ID.
2. Click on the
Connection Settings
Viewport Settings
button to display the
“Port Settings” window. Select
RS-232
as the connection type. Verify that
an available COM port is selected, and that all communication parameters
and necessary options from the “Port Settings” window are selected as
shown in the illustration below. Click the
OK
button to save the settings
and close the window.
3. Synchronize communication between the PC and the device by clicking the
Transfer Configuration
Load From Device
button. This transfers any
current settings of the C2N-DAP8 to the DAT program.
NOTE:
Before making any adjustments via the DAT program, immediately save the
program (use
File | Save As
) to preserve the current device settings. This is
especially important if you are working on a device that has already been configured
and you subsequently need to restore those settings.
“Port Settings” Window
Speaker Sizes / Bass Management
This screen lets you specify the room speaker arrangement, and set the crossover
frequency for the subwoofer.
