Operation
The C2N-AMP-4X100 can be controlled from the front panel.
Power
l
Move the POWER switch to
┃
to turn on the C2N-AMP-4X100.
l
Move the POWER switch to
;
to turn off the C2N-AMP-4X100.
Status LEDs
l
PWR: The PWR LED indicates standby or booting up (amber), or
power (green).
l
NET: The NET LED indicates communication with a Cresnet system.
l
FAULT: When lit, the FAULT LED indicates a temperature, DC, or over
current fault condition.
Route Sources
Select sources and rooms to connect to the selected source. Multiple
rooms can be connected and disconnected from a source.
Select a Source
Press a SOURCE button. The associated SOURCE LED will light.
NOTE:
If a room is already connected to the source, its associated
ROOM LED will light.
Connect a Room to a Source
With a source selected, press any ROOM button to connect it to the
source. The associated ROOM LED will light.
NOTES:
l
If SPEAKER OUTPUTS 1 and 2 are bridged, the ROOM 1 button and
LED act in unison with the ROOM 2 button and LED.
l
IF SPEAKER OUTPUTS 3 and 4 are bridged, the ROOM 3 button and
LED act in unison with the ROOM 4 button and LED.
Disconnect a Room from a Source
Press a connected room's ROOM button to disconnect it from a source.
The associated ROOM LED will turn off.
Adjust Room Volume
The volume level of a room is adjusted by placing the room in the Volume
Control mode.
1. Press and hold the ROOM button of a connected room for 2 seconds
to enter the Volume Control mode.
2. Press ▲ or ▼ to raise or lower the volume level in 1 dB increments or
hold ▲ or ▼ to ramp the volume up or down in 1 dB/0.1 second
increments.
NOTE:
If the maximum or minimum volume level is reached, all of the
LEDs will blink 3 times.
3. Press the ROOM button to exit the Volume Control mode.
NOTE:
If ▲ or ▼ is not pressed for 10 seconds, the device will exit the
Volume Control mode.
7
C2N-AMP-4X100 and C2NI-AMP-4X100
Quick Start
4-Room Audio System
