Wall Mount Back Box for STX-1550CW Crestron
BB-1550CW
6
••
Wall Mount Back Box for STX-1550CW: BB-1550CW
Installation Guide - DOC. 5848
2.
Using a stud finder (or equivalent), locate the right-edge of a stud
within the installation area.
3.
Align the left dashed, vertical line (labeled STUD EDGE) of the
supplied template with the right-edge of the stud. Refer to “Appendix:
Cutout Detail of Supplied Template” on page 10 for an illustrative
reference.
4.
Using masking tape, fasten the supplied template to the wall; verify that
the cutout is level.
5.
Using a preferred method, transfer the cutout area of the template to the
gypsum board at the location of the back box.
6.
Using a gypsum board saw (or equivalent), cut the rectangular area
through the wall.
7.
Remove the template and cutout area.
NOTE:
To prevent the mounting bracket from falling into the wall cavity, it is
recommended to tie a safety string to the bracket when performing the next step.
8.
Refer to the diagram on the next page. Through the cut-out area,
position the mounting bracket at the edge of the stud (flush with the
back-side of the gypsum board) and
vertically centered
in the cut-out
area. Through the mounting bracket slots
closest to the center
of the
bracket and using a #2 Phillips screwdriver, secure the bracket to the
stud using
four
wood screws (not supplied).
Secure Mounting Bracket to Stud
