Crestron
APAD
Wall Mount LCD Controller
LCD Brightness
LCD Brightness
Use the Nav Wheel to select the desired brightness percentage value, from 01 to 99,
in single digit steps (01, 02, 03, etc.), or use the
<<
and
>>
soft buttons to change the
number in most significant digit steps (10, 20, 30, etc.).
Note that holding any of the soft buttons for more than 10 seconds while going into
setup mode will reset the brightness to the default (22%).
Press the
Default
soft button to return to the default setting; press
Ok
to accept the
new setting and return to the
Setup Mode
screen.
Screen Invert
Screen Invert
Use the soft buttons to turn screen inversion on or off. (“Off” is normal appearance –
white text on black screen. “On” is inverted appearance – black text on white screen.)
Press the
Default
soft button to return to the default setting; press
Ok
to accept the
new setting and return to the
Setup Mode
screen.
LCD Contrast
LCD Contrast
Use the Nav Wheel to select the desired LCD contrast percentage value, from 01 to
99, in single-digit steps (01, 02, 03, etc.), or use the
<<
and
>>
soft buttons to change
the number in most significant digit steps (10, 20, 30, etc.). Note that two contrast
settings are required: one for invert on, and one for invert off.
Note that holding any of the soft buttons for more than 10 seconds while going into
setup mode will reset the contrast to the defaults (non-inverted contrast 72%; inverted
contrast 66%).
Press the
Default
soft button to return to the default setting; press
Ok
to accept the
new setting and return to the
Setup Mode
screen.
Key Backlight
Key Backlight
Use the Nav Wheel to select the desired key backlight percentage value, from 01 to
99, in single-digit steps (01, 02, 03, etc.), or use the
<<
and
>>
soft buttons to change
the number in most significant digit steps (10, 20, 30, etc.).
Press the
Default
soft button to return to the default setting (30%); press
Ok
to accept
the new setting and return to the
Setup Mode
screen.
Standby
Standby
Use the Nav Wheel to select the desired standby minutes, from 0 to 120, in single-
minute increments, or use the
<<
and
>>
soft buttons to change the number in ten-
minute increments (10, 20, 30, etc.).
Press the
Default
soft button to return to the default setting (10 minutes); press
Ok
to
accept the new setting and return to the
Setup Mode
screen.
Key Click
Key Click
Use the
ON
and
OFF
soft buttons to turn the Key Click feature on and off (default is
off).
Press the
Default
soft button to return to the default setting; press
Ok
to accept the
new setting and return to the
Setup Mode
screen.
Operations & Installation Guide – DOC. 6455
Wall Mount LCD Controller: APAD
•
13