2-Series Integrated Dual Bus Control System
Crestron
AV2 & PRO2
Memory Card Removal
1. Loosen the screw that secures the memory slot cover located to the left
of the
COMPUTER
port on the rear panel.
2. Pull on the screw to remove the screw and cover.
3. Press the eject button located on the extreme right of the slot.
4. Observe handling precautions of the memory card manufacturer and
remove card from the slot.
5. Align and reposition cover over slot.
6. Tighten the screw.
Bussing Strip Installation
The 2-Series integrated dual bus control system is supplied with two brass bussing
strips to facilitate commoning (linking) of multiple terminal block connections. The
bussing strips are constructed with four terminal block position, and may be trimmed
to size for various applications or different devices. One strip is supplied for each
8-position terminal block.
1. To utilize the bussing strip, determine the number of relays to be
commoned for the equipment being installed. If less than four, the strip
can be trimmed to size with a pair of scissors or wire snips.
2. Loosen the terminal block screws and insert the first leg of the bussing
strip into the first common position on the terminal block. The strip
engages the other common positions automatically.
3. Remove approximately 1/8" of the jacket from the common wire and
insert the conductor into one of the terminal block common positions.
Tighten the terminal block screws to lock the wire and bussing strip
into place. Insulate the strip by folding a piece of ¾" wide vinyl
electrical tape (such as Scotch 33+) over the spine and as much of the
individual legs as possible. Excess tape at each end of the strip should
be pressed closed, then trimmed to within approximately 1/16" of the
end of the strip.
4. When wiring the remaining conductors, remove approximately 1/8" of
the jacket and insert the wires into the proper terminal block positions.
To prevent the possibility of electrical shorts, it is essential that these
conductors do not touch any uninsulated portion of the bussing strip.
5. Securing a tie wrap around the bussing strip is a useful way to strain
relieve the wires connected to the terminal block.
Network Wiring
The four-wire network cable is used to power Crestron devices. Before making any
four-wire network connections, refer to the network interconnection after this
paragraph and the cautions that follow.
14
•
Integrated Dual Bus Control System: PRO2 & AV2
Operations Guide - DOC. 5957
Summary of Contents for 2 Series
Page 1: ......
