Anti-collision Protection
While the system is designed to
minimise the chances of injury, the
operator must ensure they are clear
of the desk while it is in operation
to avoid any chance of body parts
becoming entrapped between the
moving desk and other fixed objects.
Some instances where anti-collision
may not activate include:
• “Soft collisions” where the
obstruction offers insufficient
resistance to activate the system.
This includes items such as cables,
items of clothing, delicate objects.
• In some instances with heavily
loaded desks the system interprets
the load as an obstruction when
adjustment is started. To avoid
false activation of anti-collision the
controller is default programmed to
de-activate anti-collision for approx.
one second to enable adjustment to
begin.
Motiv features an anti-collision
protection system where if sudden
resistance is detected during
operation the table reverses direction
a small distance then stops. Display
will show ‘E16’. Remove obstruction
and press ‘up’ or ‘down’ button to
resume operation. The resistance
trigger force and minimum base
height setting can be adjusted as
follows:
1. Press ‘S’ button for 2 seconds until
display flashes.
2. Press ‘up’ and ‘down’ buttons
simultaneously for 5 seconds.
3. Press ‘1’, ‘2’, ‘3’ or ‘4’ to set
appropriate resistance: ‘1’ = OFF,
‘2’ = low resistance, ‘3’ = medium
resistance, ‘4’ = high resistance
Warning! – This desk is fitted with an Anti-collision system to enhance
operational safety, however the operator should take all precautions to
avoid possibility of collisions or jamming of objects.
Diagnostics
Display shows ‘EOI’:
Overload protection circuit has been
triggered — remove some weight or object obstructing free
movement and push ‘up’ or ‘down’ button to resume normal
operation.
Display shows ‘HOT’:
Overheat protection has been
triggered — stop operation for at least one minute before
resuming use.
Display shows ‘ASR/RST’ error code:
Reset base by holding
‘down’ button for 10-15 seconds until it reaches its lowest
point and ‘070’ height setting appears on display.
Display shows ‘E07/E08’ error code:
Legs not moving
uniformly - Reset base by holding ‘down’ button for 10-15
seconds until it reaches its lowest point and ‘070’ height
setting appears on display. If fault persists or only one leg of
desk operates it indicates a possible gearbox or driveshaft
malfunction - please contact your dealer for advice.