Stereo Crossover
HF
Out
LF
Out
HP 1
HP 2
LP 1
LP 2
IN
+
-
G
Vosc
CH B
Power
Amp
I/F
ckt
ID
ckt
NexSys®
Module Bus
N-Coder
DATA
PORT
Gain
Gain
Freq
Freq
Freq
Freq
Trim
Trim
Atten
Atten
HP 1
HP 2
LP 1
LP 2
IN
+
-
G
Freq
Freq
Freq
Freq
Trim
Trim
HF
Out
LF
Out
CH A
Daisy Chain
CH B
Daisy
Chain
CH A
CH B
CH A
Power
Amp
B L O C K D I A G R A M
Crest Audio Inc.
100 Eisenhower Dr., Paramus NJ 07652 USA
TEL
: 201.909.8700
FAX
: 201.909.8744
http://www.crestaudio.com
Printed in USA
N C - S C O
I n p u t P r o c e s s i n g M o d u l e
C O N T R O L O P T I O N S
The following NC-SCO para-
meters can be controlled by the
hand-held N-Coder, N-
Coder/PC software, or via
NexSys software.
N-Coder:
Channel A & B attenuation,
phase reverse, trim and frequen-
cy for high & low pass
N-Coder/PC software:
Channel A & B attenuation,
phase reverse, muting, trim and
frequency for high & low pass
NexSys computer control:
Channel A & B attenuation,
phase reverse, solo, muting,
input and output VU metering,
trim and frequency for high &
low pass
S P E C I F I C AT I O N S
Crossover frequencies:
8Hz-80kHz
Input impedance:
50k
Ω
Dynamic Range:
107dB typ.
Common mode rejection:
90dB typ.
Frequency response:
20Hz-20kHz, ± .25dB
Programmable gain range:
0 to -83dB
Voltage gain/input sensitivity:
X20 (26 dB),
X40 (32 dB),
or constant sens. for full output at 0dBu (.775V) in
Connectors:
Balanced inputs and
unbalanced HP /LP daisy-chain outputs
on barrier strip connectors
with 0.325" (8.3mm) screw center
and 0.270" (6.9mm) lug space,
RJ-14 (‘RJ-11 6-pin’) N-Coder data port
Controls:
2 gain attenuators (w/removable knobs)
v. 2.1
4/7/97
*A3300030*
Crest Audio reserves the right to make improvements in manufacturing or design which may affect specification. Crest Audio specification literature is available in electronic form to qualified users.
Contact Crest Audio Inc. for more information. NexSys is a registered trademark of Crest Audio Inc. ©1996 Crest Audio Inc.
