CKd Owner’s Manual
8.
Analog Audio Inputs
The CKd uses one 3-pin mini Euroblock connector per channel for
balanced line-level audio input. These inputs can also be setup to
accept an unbalanced signal.
Use Ferrite Beads included
with the unit
on the wires (8 Ferrite Beads included - one per channel)
.
See figure
below.
9.
NexSys Module Bay
The rear panel of a CKd Power Processing amplifier provides a
module bay configured to accept interchangeable plug-in modules.
Your amplifier may have been factory configured with
one
of the
optional modules. In this case, additional information on the relevant
modules will be enclosed in the amplifier box, or in a separate binder.
If
all required information is not included, please call Crest Audio’s
Customer Service department or your local Crest Audio
representative
10. Relay Fault Outputs
Each channel has a Fault output contact closure. When a channel
fault occurs, this contact closure will engage. These contact closures
can be further programmed using NexSys or NWare Software.
Side Panels
Exhaust Ports
The front panel fan pushes air into the unit and heated air exits through the
exhaust ports, located on the sides of the amplifier chassis. Do not block
these ports when rack-mounting the amplifier.
CKd Series Owners Manual v1e
Page
10
Ferrite Bead Installation for
Input Connections
Summary of Contents for CKd Series
Page 1: ...608 608 ...
Page 27: ......
