4
Assembling your
Cresco 10
Place the one axle bearing (Item
5) into the hole shown at the
bottom of the lower frame (14).
Feed the axle (13) through the hole
(without bearing) on the lower legs.
Push it through the gearbox and bearing
(Item 5) on the other side.
Ensure the
axle bearings are firmly in.
ASSEMBLY CONTINUED:
Place both wheels (Item 1) onto
the ends of the axle (Item 13).
Push the plastic end cap (6)
into the centre hole of the axle.
Use screwdriver and wheel cap
screws (7) to tighten. Complete
on both sides.
Turn the spreader onto its wheels and
ensure they work correctly. Align the
holes at the bottom of the handle bar
(item 2) with the holes at the top of the
lower frame (item 14). You may need to
pull the ends apart slightly to place in
position.
Use M6x35 (11) and M6 wingnuts
to tighten as shown. Repeat on
both sides.
Protruding from the back of
the hopper body (item 16) is
the pivot bracket (20) pictured
above. Clip the L shaped end
of the control rod (item 15) into
the hole on the pivot bracket
(item 20).
B
C
10
11
D
9A
ASSEMBLING THE HANDLE BAR
AND CONTROL ROD:
12
Arrow on gearbox must
be facing forwards.
Rotate the hopper body (16) to
the position shown. Place the
gear box and impellor (4) in the
centre hole of the hopper body
(16), let it rest there.
Make sure
the arrow on the gearbox faces
forwards.
9
Take the stand (Item 3) and
place it into the protruding
M6x60 bolts (x4) (Item 9).
Tighten with the M6x30 lock
nuts (x4) (Item 10).
8
Summary of Contents for 10SW
Page 9: ...8 Slide System Explanation...
