Ovens
FL-2374-D
Rev. 3 (2/15)
Page 4 of 13
Call Toll-free: 877-CRES COR (273-7267) • Fax: 800-822-0393 • www.crescor.com
5925 Heisley Road • Mentor, OH 44060-1833
HOW TO INSTALL CABINETS:
1 . Remove all packing material from the inside and all
vinyl from the outside of oven .
2 .
Place the oven in a well ventilated area on level floor.
Clearance requirements:
3” (76mm) at the back, 2”
(51mm) at the top, 1” (25mm) at both sides .
3 . Install the pan slide racks on the sidewalls, if necessary .
4 . Slide drip pan(s) onto the bottom of the compartment(s) .
INSTALLATION INSTRUCTIONS (continued)
HOW TO REVERSE THE DOOR OPENINGS, IF
NEEDED:
1 . Unscrew and remove the latch from the door and
magnetic strike from the cabinet .
2 . Unscrew the hinges from the cabinet body and remove
door .
3 . Remove the screws plugging the mating hinge, latch
and strike holes on the opposite sides of the cabinet
body and door .
4 . Re-mount the hinges to the opposite side of the cabinet
and door .
5 . Remount the latch and strike to the opposite side
FOR FIRST-TIME OPERATION ONLY:
NOTE:
A new oven needs to “burn off” factory oils and
glue before its first use.
Do NOT load food into oven until
this has been done!
1 . Push switch to “ON”; the light will come on .
NOTE:
The letters “LOtPr” (low temperature) will show on
the control panel until it reaches 140°F (60°C) .
2 . Press the “COOK” button .
3 . Turn the control knob to show 350°F . Push the knob
3 times to heat the unit . Run the unit like this for one
(1) hour .
4 . Turn the unit off and let cool .
5 . Wipe the inside clean with detergent and hot water .
DOOR VENT ADJUSTMENT:
Open the door(s) and move the vent tabs on the
inner door(s) as needed to release humidity.
WARNING
Air is VERY HOT when door is opened.
INSTALLATION INSTRUCTIONS (continued)
UPPER RIGHT CABINET CORNER
FAA-K5645C-001
1
60
1000CH
FAA-K5645C-001
29
208/240
3000
1
60
SAMPLE
R
C
US
R
R
MOD.
Hz.
SER.
PH.
WATTS
VOLTS
AMPS
MOD.
Hz.
SER.
PH.
WATTS
VOLTS
AMPS
5925 HEISLEY RD. MENTOR, OHIO 44060
COMMERCIAL COOKING APPLIANCE
MADE IN USA
CSA certified to UL 197 Rev. 9
IDENTIFYING YOUR CABINET:
Look for this label on the back of your cabinet . This information is needed when calling for questions or service .
HOW TO CHANGE FROM °F TO °C
(if needed)
1 . Push the switch on; the light will come on .
2 . Push and hold the “SET” button and the button in the
lower left hand corner together for 5 seconds .
You have now entered into the menu .
3 . Scroll over the”Unit” and change it to “C” , then scroll
to the “END” .