Creo Trendsetter 3244+ AL, Operator'S Manual

Page: 94 / 134

80 Chapter 4– Troubleshooting
Resetting the Emergency Stop Switch
If you accidentally press the Emergency Stop switch (located inside the
front access panel), you must reset it in order for the output device to
resume normal operation.
Figure 33: Emergency Stop Switch
To reset the Emergency Stop switch:
¾
Rotate the Emergency Stop switch 90
º
clockwise.
Removing a Stuck Plate From the Output Device
On occasion, a plate may get stuck on the drum as the result of an output
device error. You must remove the stuck plate before the output device can
return to normal operation.
If an error occurs while a plate is being loaded onto or unloaded from the
drum, the partially loaded plate must be removed, and the trailing-edge
clamps may have to be manually placed in their park position on the drum.
See
Repositioning the Trailing-Edge Clamps on page 83.
Emergency
Stop switch