18
Lotem 400 / Lotem 400 Quantum Family Site Preparation Guide
Plate Registration
For optimal registration, the reference points used by the output device should also
be used by plate bending and punching equipment. See Figure 4 for the plate
registration points.
The customer is responsible for satisfying the requirements for achieving optimal
plate registration on press.
For further assistance with specifying punches and benders to be used with the
Lotem 400 / Lotem 400 Quantum Family output device, contact a Creo customer
service representative.
Figure 4: Plate registration points
Max 750 mm (29.5 in)
No image
6 mm
Emulsion Side Up
Edge
detection
position
Max
680 mm
(26.75 in)
10 mm
Min 228 mm (9 in)
Min
311 mm
(12.25 in)
