Creo Color Controller C-80, Technical Manual

Page: 140 / 150

124 Chapter 5—Hardware and Maintenance Repairs
7. Remove the four screws that secure the fan to the rear-fan bracket. See
Figure 45 on page 124.
Figure 45: Rear fan
5.10.2 Installing the Rear Fan
1. Align the four holes in the new fan with the matching holes in the
rear-fan bracket, then insert the four screws and tighten them.
2. Place the rear fan in position at the rear of the server.
3. Guide the two locking tabs through the top of the slots, while aligning the other
four tabs with their respective slots.
4. Press the rear-fan bracket against the rear of the server, until all the tabs are in
their slots, and then move the rear-fan bracket downward until it locks into
position.
5. Reconnect the fan cable to the system board.
6. Return the side cover. See Placing the Side Cover on page 95.
7. Reconnect all external cables and power cords, and turn on the server.
5.10.3 Removing the PCI Fan
1. Review Safety Information (Multi-Language) on page v.
2. Turn off the Color Controller C-80 and peripheral devices. Disconnect all AC
power cords and external cables.
3. Remove the side cover. See Removing the Side Cover on page 94.