Creo Color Controller C-80, Technical Manual

Page: 125 / 150

109
Figure 24: Front panel connectors
16. Return the side cover. See Removing the Side Cover on page 94.
17. Reconnect all external cables and power cords, and turn on the server.
5.6.5 Replacing the Central Processing Unit (CPU)
Preparing to Remove the CPU
1. Review Safety Information (Multi-Language) on page v.
2. Turn off the Color Controller C-80 and all peripheral devices. Disconnect all
external cables and power cords.
3. Remove the side cover. See Removing the Side Cover on page 94.
4. Remove the FusionRA board. See Removing the FusionRA Board on page 99.
5. Remove the rear fan.
See Removing the Rear Fan on page 123.
Removing the CPU Fan and Heat Sink Assembly
1. Locate the CPU on the system board.
Note:
T
he microprocessor speeds are automatically set for this server so you do
not need to set any microprocessor frequency-selection jumpers or switches.
Attention: When you handle static-sensitive devices, take precautions to avoid
damage from static electricity.