ODC SUPERSPORT XR
OUTDOOR DISCOVERY CRAFT
ASSEMBLY INSTRUCTIONS
I. PLASTIC SEAT ASSEMBLY
1.
Assemble Seat Back to Seat Bottom using Seat Assembly Pins (see figure 1a).
II.
ASSEMBLE FRAME
NOTE:
Your Frame Assembles using (8) Short Snap Pins. Please follow instructions accordingly.
1.
Assemble Seat to Seat Support Frame Member using (4) Seat Screws. (See Figure 1a)
2.
Assemble Seat Support Frame Member to Left and Right Frame Members using (4) of the Short Snap Pins. (see figure 1)
3.
Assemble Cargo Deck to Left and Right Frame Members using (2) Short Snap Pins (see figure 1).
4.
Assemble Foot Bars to Left and Right Frame Members using (2) Short Snap Pins (see figures 1).
II.
PONTOON INFLATION
NOTE:
Use the large cone Adaptor provided with your Pump. See figure 3b for a detail of the Valve Assembly.
Before inflation,
be sure to fully seat each Valve Assembly into the Pontoon, screwing tightly by hand. When fully seating Valve Assembly,
be sure that the Valve Plate is in place around Valve Assembly and not restricting the Valve Assembly from a full seal.
After inflating, be sure to fully seat the top cap on to each Valve Assembly, screwing
tightly by hand. Both are required for an airtight seal.
1.
Inflate each Pontoon. The Valve is located inside the Storage Pocket of each Pontoon.(see figure 3).
Inflate until firm (do not over inflate).
2. Again, be sure top Valve Cap and Valve Assembly are fully seated.
PONTOON dEFLATION:
Unscrew entire Valve Assembly from Pontoon.
III. ATTACH PONTOONS TO FRAME
NOTE:
Always inflate the Pontoons first, before attaching to Frame.
1.
Position inflated Pontoons under the Left and Right Frame Members with ODC SUPERSPORT XR
logos oriented to the
outside.The Frame Members fit around the Storage Pockets.
2.
Attach Pontoons to Frame as illustrated in figures 3 and 3a.
NOTE:
Be sure the Straps are pulled tight through the
Cam-lock Buckles. Frame should be positioned forward or aft on the Pontoons to achieve center of gravity for an even
ride when fully loaded on the water.
IV. OAR & OARLOCK ASSEMBLY
1.
Loosen the wingnut on the Oarlock and slide the Oarlock onto the handle end of the Oar Shaft.
2.
Attach blade end of Oar Handle to end of Oar.
3.
Place Oarlock Shafts into Frame.
4.
With the Oarlocks installed on the Frame, the oars should be equally adjusted left and right allowing at least two
thumbs’ distance between the Oars, to avoid pinching your thumbs when rowing. With the blades perpendicular to
the water, tighten the wingnuts.
V. ATTACH STRIPPING APRON TO FRAME
1.
Snap front two Straps around the Frame underneath the Oarlocks, and snap the back two Straps to the Seat Back Frame.
just below the Padded Back and just above the Seat Bottom Frame.
TM
TM
