3 of 2
LPN000245_A
www.creebulb.com
© 2018 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change.
See creebulb.com/warranty for warranty and specifications. Cree® is a registered trademark, and the Cree logo is a trademark
of Cree, Inc.
FCC NOTICE
CAUTION:
Changes or modifications not expressly approved could void your authority to use this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved could void your authority to use this equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
CAN ICES-005 (B)/NMB-005 (B)
In compliance with CA Proposition 65, note that this product contains a chemical known to the state of California to cause cancer, birth defects or other
reproductive harm.
WARRANTY
100% SATISFACTION GUARANTEE: This product is guaranteed to give 100% performance satisfaction subject to the Cree limited warranty, the terms
of which can be found at creebulb.com/warranty. If within 10 years from the date of purchase you are not completely satisfied with the performance of
this product, please contact Cree for replacement instructions.
10
9
Wire Nut
Base Wire
Adapter
6" or 4 " Disk
Light
Disk Light
Mounting
Bracket
6" or 4 " Disk
Light
8-18 x 1"
Machine Screw
STEP 4:
Connect the ground wire from the disk light to the ground wire in the junction
box using one of the provided wire nuts.
Connect the orange female connector from the disk light to the orange male
connector that extends from the base wire adapter. See
Figure 9
.
STEP 5:
Remove the lens from the light by detaching the lens with the lens removal tool.
See
Figure 1
.
STEP 6:
Using the two 8-18 x 1/2" thread forming screws, attach the disk light to the
junction box or to the mounting bracket if you installed one. Ensure the trim
ring on the light is flush with the ceiling.
See
Figure 10.
STEP 7:
Reattach the lens to the disk light by snapping it back into place.
MAINTENANCE
REMOVING THE LED DISK LIGHT FROM A RECESSED CAN
STEP 1:
Grip firmly on the trim ring and rotate 1/4 turn counterclockwise to unlock the
clips from the recessed can.
STEP 2:
Continue to turn counterclockwise as you pull downward on the disk light. This
will disengage the flip-clips allowing the disk light (A) to pull free.
STEP 3:
Detach the disk light from the recessed can socket.
