CREE
®
TRUEWHITE
®
TECHNOLOGY FIXTURE LIMITED CONSUMER WARRANTY
The limited warranty set forth below is given by the Cree company listed below (“Seller”) with respect to the lighting product packaged with this limited warranty (the “Product”). Your Product, when delivered
to you in new condition in its original packaging, is warranted against defects in materials or workmanship as follows: for a period of FIVE (5) YEARS from the date of original purchase, defective parts or a
defective Product returned with the sales receipt as proof of purchase to Seller, or its authorized service providers, as applicable, and proven to be defective upon inspection, will be repaired, or exchanged
for a new Product, as determined by Seller, or the authorized service provider. This limited warranty covers all defects encountered in normal use of the Product, and does not apply in the following cases:
Loss of or damage to the Product due to acts of God; fire; vandalism; civil disturbances; power surges; improper power supply; electrical current fluctuations; corrosive environment installations; induced
vibration; harmonic oscillation or resonance associated with movement of air currents around the product; abuse; alteration; accident; mishandling; failure to follow operating, maintenance or environmental
instructions prescribed by Seller in writing or services performed by someone other than Seller or its authorized service provider. WARRANTY IS VOID IF PRODUCT IS NOT USED FOR THE PURPOSE
FOR WHICH THIS PRODUCT IS MANUFACTURED. Any complaints you may have regarding the Product should be addressed to Ruud Lighting, Inc., 9201 Washington Avenue, Racine, WI 53406. Seller
shall have no liability under this warranty unless Seller is notified in writing within sixty (60) days after your discovery of the defect and the defective items are promptly returned to Seller, freight prepaid,
and received by Seller. This warranty excludes field labor and service charges related to the repair or replacement of the product. NO IMPLIED WARRANTY, INCLUDING ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, APPLIES TO THE PRODUCT AFTER THE APPLICABLE PERIOD OF THE EXPRESS LIMITED WARRANTY STATED ABOVE, AND
NO OTHER EXPRESS WARRANTY OR GUARANTY GIVEN BY ANY PERSON OR ENTITY WITH RESPECT TO THE PRODUCT SHALL BIND SELLER. (SOME STATES AND PROVINCES DO NOT
ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.)
LPN000013_J
U.S Patent no. 7,213,940
U.S and Foreign Patents Pending
Designed and Produced in USA
CreeLEDLighting.com
GREEN - GND
BLACK
BLA
CK
WHITE
WHITE
BLA
CK
WHITE
POWER
SUPPLY
120 VAC
TO LAMP
LR24 JUNCTION BOX
LR24 WIRING DIAGRAM
STEP 10:
To disconnect power for servicing, rotate the connector counter-
clockwise and pull away from the LR24.
UNIT DIMMING
Note: This fixture is capable of dimming using IEC 60929 0 ~10V
control compliant dimmers only.
STEP 11:
To connect dimmer wires, remove side panel “G” by removing
the (4) screws that hold it in place.
STEP 12:
Remove side panel knock-out “H” by inserting screw driver
blade into knock-out notch and prying apart. Connect flexible
conduit connector to the side panel as shown in Fig 6.
STEP 13:
Insert positive and neutral wires into the PCB connector (shown
in detail view of Fig 6) in the correct polarity location as shown
in Figure 6. The polarity of the connection is important to prop-
er dimmer function. Using a small flat blade screwdriver, insert
the blade into the top slots on the PCB connector and twist to
lock the wires into place.
STEP 14:
When wires are locked, replace side panel and secure using the
(4) screws provided.
STEP 15:
Reconnect power to the fixture to test.
FIGURE 3
FIGURE 4
FIGURE 5
FIGURE 6
