2 of 2
CI321X01R0_B
www.creelighting.com
© 2019 Cree Lighting, A company of IDEAL INDUSTRIES. All rights reserved. For informational purposes only. Content is
subject to change. See www.creelighting.com/warranty for warranty and specifications. Cree
®
and the Cree logo are registered
trademarks of Cree, Inc. THE EDGE
®
is a registered trademark of Cree Lighting, A company of IDEAL INDUSTRIES.
STEP 10:
Unhook the installation support
cables and tuck the cables
neatly into the housing.
STEP 11:
Place luminaire on mounting
box by sliding the luminaire so
that the (4) Luminaire Mount
Screws on the mounting box are
at the end of each slot in the
housing. See
Figure 3.
STEP 12:
Tighten (4) Phillips screws and
verify luminaire is secure. See
Figure 1
.
ELECTRICAL CONNECTIONS
STEP 1:
Make the following Electrical Connections to the terminal block:
a. For 120/277V connect the black fixture lead to the voltage supply
lead (Hot 1 for 208/240V wiring).
b. For 120/277V connect the white fixture lead to the neutral supply
lead. (Hot 2 for 208/240V wiring).
c. Connect the green or green/yellow ground lead to the green lead.
LINE
OR HOT 1
GREEN
LINE-BLACK
GROUND-GREEN
NEUTRAL-WHITE
NEUTRAL
OR HOT 2
SUPPL
Y WIRING
LUMINAIRE
7.0"
6.0"
Mounting
2.4"
Mounting
3.4"
5
(4) Mounting Holes
for 3/16" Customer
supplied Screws
Keyhole Knockouts- Provided for
Alignment Over Junction Box
ONLY
1/2" Conduit Knockout
2-2/12" Inspection Knockout Hole for
Mounting Over Recessed Junction Box
4
3.500" Min. Box Mounting
Ht. to Achieve 3" Required
Clearance Above Fixture
