3 of 5
LPN00429X0001A3_B
STEP 5:
Remove the pink EPE plastic foam from over the LEDs by
removing each piece of blue tape.
STEP 6:
Bring the retrofit side panel up to the existing troffer pan and
connect the ground wire on the back of the side panel to the
retrofit main assembly as shown in
Figure 6.
Tuck the ground
lead up into the main assembly.
STEP 7:
Insert the edge of the side panel, that is opposite of latches,
between the existing troffer pan and t-grid. Then insert
the other side into the retrofit main assembly by engaging
the 2 latches on the side panel into the 2 slots on the main
assembly. See
Figure 6 and 7.
NOTE:
Make sure not to pinch any wires, all wires should be
tucked up inside the main assembly.
STEP 8:
Install the lens over the LEDs by putting the lens flat edge
over one side of the bracket located on the main assembly.
While pushing on the middle of the lens, to widen the lens,
insert the other flat end of the lens over the other side of the
bracket. See
Figure 8 and 9.
5
6
7
8
Sliding End
Cap
Retrofit Main Assembly
Bracket
Retrofit Side Panel
Ground Wire
Retrofit Side Panel Latch
Lens
Retrofit Main
Assembly Bracket
Lens Flat
Edge
Safety Cable
Edge of Side Panel insert into
Existing Troffer Pan
Ground Wire
Attached to Main
Retrofit Assembly
Lens
9
