Replace the inner front, complete with insulation, by locating its bottom edge behind the front
lip of the chassis and inserting the retaining screws along the top and sides.
The outer front/top panel assembly can be hooked over the rear panel top flange. Ensure
no wires are trapped between the panel flanges before replacing and tightening the three
screws at the rear of the top panel and the three screws along the bottom edge.
The lower front panel can now be fitted by locating the tabs (one on the 70305S and two on the 70315S) into
the corresponding slots in the bottom face of the front panel. The two black screws should now be replaced
at each side of the heater. Finally tighten the screws at each end of the wall bracket.
Refit the control knob under the lift-up flap, taking care to align the flat on the spindle.
PLEASE ENSURE THAT ALL POLYSTYRENE AND CARDBOARD PACKING PIECES HAVE BEEN REMOVED.
ENSURE WALL BRACKET SCREWS ARE TIGHTENED FULLY.
WARNING. When a new heater is run up to temperature, the materials will produce a slight smell for the first
few days, these are normally harmless in a well ventilated room. It is best to make these first overnight charges
with the ‘Room Temp’ control knob at ‘6’ and High Fan selected (II). Caged birds, young children and people
with chest ailments are best kept out of the room for the commissioning period.
11
12
SETTING THE CONTROLS
The controls are located under
the lockable flap at the right hand
corner of the top panel.
Allow the heater to run for two
nights as described above in order to quickly
disperse the new smell.
Please ensure the Owners Guide is passed on to
the User.
Part No. 84702
Iss. No. 10
11/11
10
Fit the front layer of bricks with the recess
toward the front of the heater.
The complete core will comprise:
70305S - 3 x 4 brick columns
70315S - 4 x 4 brick columns
