1. GENERAL
The appliance is designed for mounting at a safe level into an oven housing
which must be secured to the backing wall.
2. VENTILATION
a.
The oven housing unit cabinet dimensions must comply with fig. 4.
b. An air gap of 30mm minimum must be provided at the rear of any top or bottom
cupboards or shelves (see fig. 1).
c.
It is necessary that the cabinets are provided with unobstructed ventilation, i.e. from
adjacent cabinetry. This can be done by either raising the base of the cabinets using
the adjusting feet (or spacers) or alternatively by providing a slot in the cabinet
plinth to the dimensions in fig. 1.
d. The air gap at rear allows the warmed air to pass out of the inner cabinet space.
Where it is intended to fit cupboards above the oven unit to ceiling height, it is
essential that the warmed air is exhausted through the front of the cabinet (see fig.
1).
e. If an oven unit is installed adjacent to a tall cabinet, steam escaping from the oven
when the door is opened could condense on and maybe stain the adjacent surface.
To prevent permanent staining, the adjacent surface should be made of a material
that is heat resisting and easy to clean. Adjacent tall cabinets should not be deeper
than the oven housing cabinet.
3. FINAL INSTALLATION
a.
Using a spirit level, check that the housing cabinet is level from side to side and from
front to back in its installed position.
b. Correct any unevenness by placing spacers under the bottom of the cabinet.
Make sure that the cabinet rests firmly on the floor without rocking.
c.
Before the oven is fitted, the cabinet must be firmly secured to the backing wall for
stability.
d. The oven unit should now be lifted (this is a two person lift) into the cabinet and
pushed fully home.
e. Finally, the oven is secured to the cabinet by means of the four Pozi Wash
Head screws - two through each side trim.
f.
Remove all packaging material from the grill and oven interior.
LIST OF LOOSE ITEMS
4 x Pozi Wash Head No. 6 x 15mm screws.
INSTALLATION
29
Note: This appliance must not be installed over any other appliance that
generates heat.
