13
INSTALLATION
Fig. 1
IMPORTANT
Minimum unobstructed depth
50mm
Worktop thickness
Preferred 30-40mm
19mm minimum
recommended
30mm
490mm
560mm
Front edge
of worktop
Fig. 2
40mm
worktop
Outside base of hob
Inside base of hob
30mm
worktop
FIXING CLAMP
Note: Do not over tighten the hob clamps as distortion of the hob may occur.
FITTING THE HOB
Unpack the hob from the carton.
Remove the bag containing the sealing tape, fixing brackets and screws.
Fit the sealing tape around the edge of the cut-out in the worktop.
Lower the hob into the worktop ensuring the mains lead is fed into the base unit and is not
trapped under the flanges.
Fix the hob to the worktop using the fixing brackets and screws (see Fig 2) ensuring at the
same time it is pushed forward and to the right within the cut-out. The brackets can either
be hooked into the base panel slots or used to form a bridge between the panel and the
worktop. Brackets fitted in the corners can either be fitted across to the sides, front or back
of the worktop.
NB Do not over tighten the hob clamps as distortion of the hob may occur.
Connect the hob to the electrical supply (see INSTALLATION).
Ensure that the hob is functioning correctly prior to use. Instruct the user in the operation
of the hob.
