8
5.
Re-fit the detachable bottom section with the two screws if it was removed.
6.
Locate and connect the front cover power supply cable as shown (diagram 5) ensuring that the lead
is routed away from the heat exchanger. Take care not to damage the pins when connecting.
7.
When re-fitting the front cover
a.
Ensure the top control knob pointer is set to the 12 o’clock position as shown (Diagram 4a).
b.
Ensure the pointer of the bottom control knob is aligned to 6 o’clock as shown (Diagram 4b).
c. In the main body of the shower ensure the “raised pip” of the “camshaft”, positioned to accept the
top control knob, is set to 12 o’clock (Diagram 4a).
d. In the main body of the shower ensure the “bottom gear wheel”, positioned to accept the bottom
control knob is turned fully anti-clockwise as shown (Diagram 4b).
Then secure by replacing the top and bottom fastening screws
e. Check that the top control knob has been correctly aligned by ensuring that all three power
settings can be selected.
f. Check that the bottom control knob has been correctly aligned by turning clockwise and ensuring
that the knob turns approximately one full turn and when turned back fully anti-clockwise, returns
to 6 o’clock.
7.
Fit the shower hose, and operate the shower first without the handset to flush out particles,
fit the handset and then operate the shower as on page 10 or 16 and check:
a.
Water gets to a satisfactory temperature and water flow can be adjusted by control knob “C”.
b.
Power selection operates in all 3 positions, giving a change in water temperature.
c.
Check again for leaks and that the holes in the shower handset are not blocked.
8.
Demonstrate the showers operation to all users.
9
ASSEMBLY OF ACCESSORIES
Diagram 6 -
Riser Rail and Soap Dish Fitting Instructions
(Refer to the separate fitting instruction sheet packed with the accessories for more details)
1.
Establish height of riser rail to suit user requirements.
This should be a maximum of 0.6 metres (2ft) above the level of the heater, see (a) below.
2.
Remove covers from the wall brackets (b).
3.
Position the lower bracket and mark the wall for the screw fixing (c).
Then drill and plug the wall and fix the lower bracket
without
the rail location notch.
4.
Fit the rail into the lower bracket.
Place the remaining bracket
with
the rail location notch on top of the riser rail, making sure that the
rail slot is located into the notch.
Ensure the hole position is vertically aligned and mark the wall (d).
Remove the rail and bracket, then drill and plug the wall.
5.
Assemble the height adjuster (e).
6.
Compress the height adjuster assembly and slide onto the rail.
Fit the hose retaining ring and then the soap dish on the bottom of the rail (f).
Lock the soap dish into position by tightening the lock nut.
7.
Replace the rail assembly into the lower bracket.
Refit the top bracket, ensuring the slot in the rail is located into the bracket notch and fix to the wall.
Slide covers onto both brackets.
NOTE: The adjustable slider grips the conical nut on the shower hose (g).
