If the application does not start, double-click the
setup.exe
file in the
Installation and
Application
CD.
NOTE:
To check the availability of newer drivers for your workstation, go to
http://www.hp.com
.
12.
After you have installed the software, see your speaker manufacturer documentation for
instructions on how to connect the speaker to your system.
NOTE:
When the sound card is installed in the system, the internal chassis speaker only functions
for diagnostic beeps and does not play any other sound. The rear audio connectors on the system
board are also disabled when the X-Fi sound card is installed. Use the audio output from the X-Fi
sound card for audio connection to the external audio device.
Shipping your HP workstation
When shipping your HP xw6000, xw8000, or xw9000 series workstation, install the shipping support
arm.
For standard desktop use, the shipping support is not required.
NOTE:
Your workstation might look different than the one shown graphics below.
Adding support arm to card support assembly (HP xw8000/xw9000 series
workstations only)
1.
Add a new arm and insert it from bottom of the housing. The new arm must support the X-Fi card,
so choose the correct location. Your workstation might have other support arms already installed
over other slots (not shown in picture).
2.
Push the arm into the housing (1). Slide the arm back to lock it in place (2).
Figure 3
Preparing the support arm
6
Creative Sound Blaster X-Fi card installation
ENWW
