Connecting With Other Devices 3-4
Setting Up Your Drive
To connect additional devices to your system, you will need to assign
an individual SCSI ID number to all devices and terminate the end
devices on the SCSI bus.
This section shows you how to:
❑
Enable and Disable Jumpers
❑
Set an ID
❑
Set a Terminator
Enabling and Disabling Jumpers
A jumper exists in two states: enabled or disabled. A jumper is
enabled when a plastic hood called a jumper block is placed over the
jumper’s two pins as shown in Figure 3-3.
In contrast, a disabled jumper is one in which the jumper block is not
placed over the jumper’s two pins as shown in Figure 3-4.
Figure 3-3: An enabled jumper.
Figure 3-4: Disabled jumpers.
