© Copyright 2004, Creative Playthings, Printed in U.S.A.
RAMP FOR 5' PLATFORM
19502-300 Rev H (05-20)
Page 2
STEP 1 - Attach Ramp
Once the desired position for the Ramp is determined, remove
Wall Slats to create a space to pass from the Ramp into the
Gym.
Attach the Access Ladder Brackets (D) to the Side Rails of
the ramp Assembly using the holes provided. Use One 5/16
x 3" Hex Bolt, one Lock Washer,
two
Flat Washers, and one
Weld Nut to fasten each Access Ladder Bracket.
Lean the Ramp Assembly into place against the Platform
Support in the position desired. Position the Access Ladder
Brackets with one surface flat against the surface of the Plat-
form Support. Mark the position of the holes in the Brackets
onto the Platform Support.
If the Access Ladder Bracket is to be fastened
to the Platform Support only, drill a hole at
the mark using a 3/8" diameter drill bit. Any
Wall Slats that may interfere should be
removed. Fasten each Access Ladder
Bracket to the Platform Support using
one 5/16" x 1-1/2" Hex Bolt one Lock
Washer, one Flat Washer, and one
Weld Nut.
If the Wall Support is backed by a Corner
Post or any other solid structure, drill a
1/4" diameter hole 2" deep. Fasten with a
5/16 x 2-1/2" Lag Screw and Flat Washer.
Platform Support
Access Ladder
Bracket
HARDWARE
HARDWARE & ASSEMBLY
5/16 x 1-1/2"Hex Bolt
5/16 x 3"Hex Bolt
Weld Nut
Lock
Washer
Flat Washer
Access Ladder Bracket
(not to scale)
5/16 x 2-1/2" Lag Screw
#8 x 2-1/2" Screw
50337-700 Hardware Bag, Ramp
4
17001-105
Weld Nut 5/16"
8
12002-206
Flat Washer 5/16"
2
17003-611
Hex Bolt 5/16 x 1-1/2"
2
17003-1211
Hex Bolt 5/16 x 3"
4
12017-206
Lock Washer 5/16"
4
17020-109
Screw #8 x 2-1/2"
2
17036-1002 Lag Screw 5/16 x 2-1/2"
2
14161-400
Access Ladder Bracket
RAMP FOR 5' PLATFORM
If the end of the 3" bolt projects more than
1/8" beyond the Weld Nut, pad the Bolt
with extra Flat Washers.
