Page 2
©
Copyright 2002, Creative Playthings. Printed in USA
ASSEMBLY INSTRUCTIONS
SKYBOX PLAYWALLS
PLEASE CONSULT YOUR ORIGINAL GYM ASSEMBLY MANUAL FOR
MAINTENANCE AND SAFETY INSTRUCTIONS
19491-300 Rev E (03-21)
SKYBOX PLAY WALLS
STEP 2 — WALL SUPPORTS
Mount the End Wall Support (A) to the back of the
Skybox posts using two 5/16 x 2-1/2" Lag Screws and
two 5/16" Flat Washers as shown.
Mount the Side Wall Supports (B) to the inside face of
the posts using two 5/16 x 2-1/2" Lag Screws and two
5/16" Flat Washers each, as shown.
Note: Depending on the layout of the play structure, you
may want to omit one or more walls to allow access.
STEP 3 — HOLE CAPS
Insert Hole Caps into the counter-bored holes in the
Walls Supports to cover the fasteners.
STEP 4 — WALL SLATS
The End Wall Support is slightly higher than the Side
Wall Supports. The Walls Slats (C) are to be fastened
to the wall supports at the top and Skybox base at
the bottom. When placing the wall slats be sure the
screw holes overlap the wall supports and skybox
base equally.
Secure seven wall slats to the end wall support and
Skybox base using four #10 x 1-5/8" screws each.
Space them evenly between the posts.
Secure five wall slats to each side wall support and
Skybox base using four #10 x 1-5/8" screws each.
Space them evenly between the posts.
Gaps ≈ 2-1/2"
Gaps ≈ 1-5/8"
5/16 x 2-1/2"
Lag Screws
1" Hole Caps
A
B
B
C
#10 x1-5/8"
Screws
