www.cls-led.com
CLS manuals
CLS Zense
- 7 -
- 8 -
CLS Zense
CAT5 UTP cable max. 15 m
RJ45 Splitter
DMX fixture
RJ45 to XLR cable
RGB fixture
CLS Zense
CAT5 UTP cable max. 15 m
RJ45 Splitter
DMX fixture
RJ45 to PWR cable
RJ45 to XLR cable
Power supply
Example: The CLS Zense with other DMX fixtures (e.g. the CLS LED PAR RGB).
The CLS Zense can be connected with the supplied connector kit. Standard straight CAT5 UTP cabling can be
used between the splitter and the CLS Zense.
COMBINED SYSTEM
It is also possible to use the DMX and Direct drive together. However, this is only possible for SINGLE colour
(1 channel DMX) and RGB (3 channel or with master 4 channels DMX). The CLS Zense uses the power that is
connected to power the voltage-controlled LED product. The same colour and brightness setting is sent out
via DMX. This makes it possible to control the colour of the RGB fixture and also of the DMX fixture. Be aware
that not all LEDs are exactly the same, it is possible that there is a slight difference in colour.
As described in the table above the direct drive system allows a maximum of three channel control.
• 1 Channel can be used to control single colour LED products. The Zense only uses the brightness control.
• 3 Channels can be used for LED products with RGB.
The colours that are controlled are the same for direct drive as for DMX, however the direct drive can support
only up to 3 channels.
1 Channel 3 Channels 4 Channels 5 Channels Master
Direct control
√
√
DMX controll
√
√
√
√
√
CONFIGURATION
After the installation is done the CLS Zense must be configured.
Step 1
To access the configuration mode place your finger on the
Program button while tapping three times on the brightness
button within 3 seconds.
When configuration mode is entered LED [I2] starts flashing
3 x
A
B
Step 2
By placing your finger on the colour button you are able to
configure the channels of the CLS Zense. Move your finger
over the slider to adjust the setting.
LED [I2] is flashing
LED L1 on:
Single colour
(Direct drive and DMX)
LED L1-3 on: RGB
(Direct drive and DMX)
LED L1-4 on: RGBA or RGBW (DMX only!)
LED L1-5 on: RGBAW
(DMX only!)
3 x
A
B
3 x
A
B
Step 3
By placing your finger on the Brightness button, you are able to
configure the master channel of the CLS Zense. Move your
finger over the slider to adjust the setting.
LED [I1] is flashing
LED [L1]: Master ch. Off
LED [L2]: Master ch. Behind (master is added behind colour channels)
LED [L3]: Master ch. Before (master is added before colour channels)
The master function only applies for DMX!
