background image

My led’s are too bright is there a way to turn them down or off?         
 

Yes,  there is a switch inside the machine behind the coin door that will turn off the led’s.  We also have available a dimmer 

switch that can be installed to turn the lights down or up.

My machine wont take my quarter what am I doing wrong?
 

Before your machine will take quarters,  you have to put a quarter in the caddy of the coin device.  To do this you lift up on 

the part that has the green QC sticker and put your quarter in the slot of that caddy.
 

You know when it is in correctly because when you insert a quarter in the front,  it will fall all the way through.

How do I setup my machine to accept quarters ?
 

Depending on your machine,  you have to get into the setup portion of it and take it off of freeplay mode.  If you are unsure or 

unfamiliar with the setup portion of your machine,  then give us a call and we will help you.

How do I setup my machine to accept tokens?
 

You setup your machine to accept tokens the same way you would set it up to accept quarters.

How do I exit out of a game?
 

To exit out of a game just simply hold down the Player One button until it either takes you out or asks you to confirm by 

clicking on exit with the one player button again.

I started a two player game and it doesn’t switch to the other side
 

There are a few games that were only made as a stand up arcade game so those games only know to use Player one 

Controls.  OR your machine is defaulted to either stand up arcade or cocktail arcade and if it is wrong then this will happen.
 

If you are unsure just give us a call.

Is there anything I can do to make my trackball work better?
 

If your trackball becomes dirty or sticky or non responsive you could loosen up the control panel and tighten up your 

trackball by slightly tightening the nuts on the bottom of the trackball a little at a time.  We do not recommend cleaning 
 

Your trackball with any kind of solution (windex or 409)  chemical based cleaners would have a negative effect on the 

trackball.  We recommend some diluted simple green if you must clean it.

My joystick wont go up/down/right/left whats wrong?
 

When this happens we usually ask the customer to open the control panel and look at the wires that are connected to the 

joystick to make sure that they are all still connected securely and none are loose or broken.  If everything is connected
 

Then try switching with the other joystick to see if the problem follows the stick or the station. 

Why didn’t my game keep my High score?
 

The only system that keeps high scores is our 60 to 1 Not sure why none of the others will keep the score but I believe that 

the new release is going to be able to save scores.

Summary of Contents for 3500-4P










Reviews: