Creality 3D Print Mill, User Manual

Page: 13 / 24

6
�. First move the X axis to the contact part between the nozzle and the belt (slightly press the nozzle onto the belt ) . �. Push the two limit switches against the X sliding block to lock
the limit; �. Press back on the screen to get the printer back to the origin; adjust the Y axis end-stop adjusting screw according to the position of the nozzle relative to the belt after
back to the origin in order to make sure the nozzle contacting with the belt rightly; then tighten the Y axis end-stop screw, leveling finished; �. if there is any seam or over contact
between the nozzle and the belt, adjust the leveling nut slightly.
Leveling
The even filament adheres right on the
platform.
The nozzle is too close to the platform,
the consumables are not extruded
enough, and the nozzle outlet is
damaged.Causes a plug and scratches
the belt.
11
4
A Y axis end-stop adjusting screw
B
Y axis end-stop adjusting the screw
3
A
B
2
1
調平
Y 軸限位安裝螺絲
Y 軸限位調節螺絲
噴嘴離平台太遠，耗材無法黏附在平台上。
噴嘴離平台太近，耗材擠出不足，噴嘴出口
損傷，造成堵塞，刮傷皮帶。
耗材擠出飽滿均勻，剛好貼在平台上。
1. 先把 X 軸移動到噴嘴與皮帶接觸位置 ( 噴嘴微壓皮帶 ) 2. 將兩個限位開關頂著 X 滑動塊鎖緊。 3. 選擇螢幕中的回原點，使得機器自動回原點，根據回原點後噴嘴與
皮帶的相對位置調節 Y 軸限位調節螺絲 ; 使得回原點後噴嘴正好與皮帶接觸，鎖緊 Y 軸限位安裝螺絲，調平完成。 4. 如果發現噴嘴與皮帶有間隙或者接觸過多，可微
調調平螺母調節。