Smartwasher
SW-37
Operating Manual
|
4
1.
Remove the OzzyMat
®
from its package, unfold it and lay it on
the mat support grid located in the lowest level in the sink. Make
sure to lay the OzzyMat
®
white side up.
2.
Place the false bottom in position in the sink.
3.
Form the flexible nozzle to its desired shape and be sure that
the parts brush is inside the sink.
4.
DO NOT PLUG UNIT IN BEFORE ADDING OzzyJuice
®
.
5.
At start up, carefully add 100L (5x 20L containers) of OzzyJuice
®
to the SmartWasher
®
by slowly pouring the solution directly
into the sink.
6.
Plug the unit into a 220VAC GFCI electrical outlet.
7.
The SmartWasher
®
will take approximately two hours to heat
up to its selected optimal temperature of 40°C (+-1°) OR
46°C (+-1°). This temperature will be maintained as long as the
SmartWasher
®
is plugged in and full of OzzyJuice
®
. (If the Add
Fluid Light is on, the heater automatically shuts off.)
37 Basket
False Bottom
OzzyMat
®
Mat Support
Grid
Drain Basket
Your SmartWasher
®
is almost ready to use.
(The OzzyMat
®
, support grid and false bottom
of the sink are packed inside the sink). Visually
inspect for damage (minor scratches and scuffs
are normal due to the molding process).
Parts Washer Setup
SET
ME UP
The SmartWasher
®
will weigh approximately 211 kg when it is filled
with fluid. It should be installed close enough to a normal 220VAC
ground fault circuit interrupter (GFCI) electrical outlet so that it can be
plugged in. The SmartWasher
®
should be the only item plugged into
this circuit.
DO NOT PLUG IN BEFORE ADDING FLUID.
1.
The pump switch is attached to a ten minute timer. Turning
the switch ON (upward position) will start fluid flowing for ten
minutes. To restart the flow, turn the switch OFF then ON
again and the flow will restart for another ten minutes.
2
Adjust the valve at the base of the nozzle to control the flow
of the fluid through the nozzle. The valve at the base of the
brush hose controls the flow of fluid through the brush. Both
outlets can be operated independently or together.
Parts Washer Operation
Change the OzzyMat
®
every
30 days or once a month to
maintain cleaning performance.
The OzzyMat
®
traps sludge
and dirt as small as 50 microns.
It works effectively even when
it appears dirty. At some
point, however, it will become
saturated and unable to pass fluid freely and should be changed. The
FL-4 Multi-layer OzzyMat
®
allows you the benefit of being able to
peel layers between mat changes.
OzzyMat
®
Installation & Setup
For technical support visit our website www.crcind.com.au/smartwasher or call us on 1800 224 227
