STANDARD CONFIGURATION
MAST CONFIGURATION
10
JET
GLIDER
ACROBATIC
JET
USING TRACK SYSTEM
GLIDER
USING TRACK SYSTEM
ACROBATIC
USING TRACK SYSTEM
EASY
EASY
USING TRACK SYSTEM
rear foot
rear foot
Position of the fuselage is good only if you position the mast on the board at 25 cm with sandwich installation and 15 cm
with track system.
If you cannot respect these measurements for any reason, compensate by sliding the mast into the fuselage of the
corresponding mesurement difference.
Example:
if the mast center on the board is 5 cm closer to the middle of the rear foot, move the mast forward on the fuselage 5 cm
towards the fin.
If the mast center on the board is 5 cm further to the middle of the rear foot, move the mast forward on the fuselage 5 cm
towards the nose.
Summary of Contents for JET 2018
