5
MULTI-ZONE CONTROLLER INSTALLATION GUIDE
For general information purposes only. Specifications, dimensions and construction not guaranteed
and are subject to change without notice. Copyright © 2020 ASP Holdings, Inc. All rights reserved.
Have questions? Call 888-503-1317
Installation
Install your light fixture and run the wires to where you’re locating your power supply
and controller/receiver.
Remove the covers from the controller/receiver and make your output wiring connections.
a. For RGBW
, white should go to W- (CH4), blue to B- (CH3), green to G- (CH2), red to R- (CH1), and black to V+.
b.
For single color dimming
, your positive wire should go to V+, and negative to any of the 4 negative terminals.
c.
For color tuning,
your positive wire should go to V+, yellow wire to WW- (CH1 or 3), and white to CW-(CH2 or 4).
Connect your positive and negative input wiring connections from the power supply to
the controller/receiver.
Identify the location to mount your light fixture, your power supply, and
controller/receiver.
3
4
5
2
Turn off power at breaker.
1
12VDC or 24VDC
Non-Dimmable Power Supply
(don't worry you'll still be able to dim)
Handheld remote
(listed on page 2)
12VDC or 24VDC
light fixture(s)
Controller/Receiver
AL-CTLR-RGBW-4CP
(one for each zone)
Turn on power and plug in the power supply
6