Cray T3E, Manual, Page: 103 / 206

AC Repair and Adjustment Procedures FRP 14: Module-to-WACS Cable Replacement
HMM-168-A Cray Research/Silicon Graphics Proprietary 103
14. Use a dental pick to carefully remove the plastic connector pin lock (P/N
01775900) from the module side of the connector. Refer to Figure 48 .
(You will replace the pin lock with a new one.)
Figure 48. Removing a Connector Pin Lock
15. Use the following procedure to release each wire in the cable assembly
from the rail connector:
a. Position yourself so that you can see the pins.
b. Identify the pin location of the wire.
c. Carefully slide the hollow tip of a 0.3-mm mechanical pencil over the
outermost pin of the pin pair. Then apply a gentle force both toward
the other pin in the pin pair and toward the wire, away from the
module area and toward the base of the rail. Refer to
Figure 49 .
d. Return to the wiremat and pull the wire from the rail.